MIG-160ER
9
- Guide the welding wire into the right opening of the wire feeder, over the wire feed roller into the left
opening of the wire feeder.
- Close the cover of the clamping system and move the star grip away from you so that the cover is
locked. Adjust the tensioner with the star grip (e.g., with 0,9 mm wire to 3.5). Do not turn the tensioner
past value 5!
- The next step is to turn on the unit, make sure the torch cord is straight and remove the nozzle and
nozzle assembly from the gun.
- You can then pull the wire to the torch nozzle either with the button on the torch or with the “Fast Wire
Drive” button. After the wire comes out of the gun, reattach the nozzle and nozzle assembly to the gun.
CONNECTION & SETTINGS
MIG/MAG welding with/without gas:
Connect the torch and the earth cable correctly, depending on whether you want to weld with or
without gas (filler wire).
Filled wire welding (without gas)
Set the appliance to "FLUX" by pressing the button (3)
