20/06/2022
xIPMIT204
7
5.1 Example - Standard WiFi Bridge
Pairing on channel 007
1. Power both IPmitters, and leave to boot up for at least 3 mins. During boot up they
will display a rotating segment
[
_i
]
2. On one IPmitter (client), press the F (function) button and "H" will flash
[
H007
]
.
Press the S (setting) button to change to
[
C007
].
3. The whole display will flash to indicate the settings have been saved, it will reboot
(can take up to 3 mins) then the display will show
[
C007
]
.
4. Now press the RST (reset) button for 1 second on both IPmitters
[
H007
]
[
C007
].
The display will change to a P with a rotating segment whilst pairing
[
P __
].
Pairing
can take up to 5 minutes.
The display will show P and a value once paired
[
P0
10
] [
P0
12
]
.
5.2 ERR Code or P-95
Note: The strength will range P-01 (Good) to P-75 (Poor).
If
ERR
shows then the IPmitters have not paired
Reset both IPmitters, holding the R (reset) button down on both IPmitters for 10
seconds. Once both units have booted back up, then try the pairing process again.
Note: Ensure the units are not plugged into the same switch / network during pairing.
If
P-95
shows the the IPmiiters have either not paired or they have lost signal.
1. Check the pairing > Reset both IPmitters, holding the R (reset) button down on
both IPmitters for 10 seconds. Once both units have booted back up, then try the
pairing process again.
2. Between P-070 and P-095 is too low for transmission > Try the pairing process
with the devices closer together.