| Assembly and installation
46
YLS-K
NOTICE
Damage to the fiber
The fiber can be damaged by mechanical stresses.
The minimum bending radius of an unloaded fiber is
100 mm. In areas where motion takes place, the min-
imum bending radius is 200 mm.
ð
When running the fiber, ensure that the speci-
fied minimum bending radius is complied with.
ð
Avoid mechanical loads (shocks, impacts, twist-
ing, etc.) on the fiber and the fiber connector.
Running of the lines and fibers
The system integrator is responsible for running the
connection lines and the fiber to the product.
Unpacking fibers
1.
Remove the cable ties or tape with which the fiber is fastened to
the product or the transport box.
2.
Remove the plastic bag at the end of the fiber.
Running the fiber
3.
Take the fiber connector in your hand and roll out the fiber with-
out twisting.
4.
Run the fiber in a suitable cable channel.
5.5
Connecting the product
NOTICE
Damage to electronic assemblies
Mechanical modifications to cabinets, plug connec-
tors or pass-through openings can reduce the IP pro-
tection class. If the protection class is lowered, dirt
or moisture could enter inside the cabinet and cause
damage.
ð
Always follow the instructions below.
ð
Attach all lines to the product such that it is possible to move the
product 1 m in any direction for assembly work.
ð
Use only the provided electrical plug connectors.