IPG Interpack USC 2024-BB 3, Operations Manual & Parts List

Page: 46 / 56

USC 2024-
BB 3” UNIFORM SEMI-AUTOMATIC CASE SEALER
Troubleshooting
6-1
Chapter 6
TROUBLESHOOTING
The USC 2024-
BB 3” Uniform Semi-Automatic Case Sealer is fabricated with high quality components that
provide trouble-free operation for a long period of time. However, should a problem occur, we recommend
that you consult the following table. If the problem you encounter is not discussed in this table, call
Interpack
Technical Support .
Trouble Possible Causes Solutions
Green start button
pressed but belts do
not turn. E-stops not reset.
Machine not plugged in.
Rotate both E-stops ¼-turn
clockwise (
page 5-5 ).
Plug machine into 115V, 60HZ, 15A
electrical service.
Motors turn but belts do
not turn. Belt tension too low. Adjust tension on drive belts.
Drive belts do not process
cases. Belt tension too low.
Case Width Adjustment is incorrect.
Case Height Adjustment is incorrect.
Collapsed leading end panel on
case.
Case size is out of specification.
Top Squeezers set incorrectly. Adjust tension on drive belts.
Re-adjust Case Width (
page 5-4 ).
Re-adjust Case Height (
page 5-3 ).
-Install lighter gauge tape head main
spring.
-Reduce unwind tension on tape roll.
a.
Mandrel tension.
b.
Clutch roller tension.
Compare case sizes with machine
specifications (
page 3-3 ).
Re-adjust Top Squeezers
(
page 5-4 ).
Case processes but top of
case is crushed. Case Height Adjustment is incorrect. Re-adjust Case Height ( page 5-3 ).
Case processes but side
of case is crushed. Case Width Adjustment is incorrect. Re-adjust Case Width ( page 5-4 ).
Case processes but
leading end panel is
crushed. Product does not support the end panel
of the case.
Main spring tension on Tape Head too
strong. Insert proper dunnage material to
provide support.
Reduce main spring tension, See
Tape Head Manual.