IPG Interpack ET 2Plus H275, Operator'S Manual & Parts List

Page: 39 / 78

39
R00
S
CHEDULE
O
F
P
REVENTIVE
M
AINTENANCE
Item Action Required Material Weekly Monthly Quarterly
Blade Guard Oiler Pad Lubricate mineral oil
X
Hardware Re-tighten any loose hardware
X
Replace any missing hardware X
Cutter Blade Inspect for wear X
Clean Solvent Cleaner X
Mandrel Assembly Disassemble & Observe X
Mandrel Sprags Check for supporting springs None x
Mandrel Friction Washer Clean Solvent Cleaner
X
Mandrel Metal Washer None
None
X
Mandrel Shaft Remove any dust and adhesive build up Solvent Cleaner X
Mandrel Bearing Check for wear None X
Peel Roller X
Delrin Roller Check for free spinning. Disassemble and
remove any adhesive build up.
Solvent Cleaner
X
Pivot Shaft Check for any restriction
Solvent Cleaner
X
Peel Roller Spring Check for weakness X
Plastic Guide Rollers Check for free spinning. Disassemble and
remove any adhesive build up.
Solvent Cleaner
X
Knurled PTFE Coated One
Direction Clutch Roller
Back off tension. Check for free spinning.
Disassemble and remove any adhesive build
up.
Solvent Cleaner
X
Knurled PTFE Coated Guide
Roller
Rotation should be slightly restricted by
Belville washer. Disassemble and remove any
adhesive build up if excessive restriction is
detected
Solvent Cleaner
X
Front Red Wipe Down Roller Rotation should be slightly restricted by
Belville washer. Disassemble and remove any
adhesive build up if excessive restriction is
detected Solvent Cleaner
X
Rear Red Wipe Down Roller Check for free spinning. Disassemble and
remove any adhesive build up.
Solvent Cleaner
X
Main Spring Remove and inspect for any wear or nicks.
Replace as necessary.
X
Knife Spring
Remove and inspect for any wear or
weakness. Replace as necessary.
X
Tape Shoe Guide Flat Spring Inspect for any wear or weakness. Replace as
necessary.
X
Wipe Down Tabs Inspect for any wear or breakage. Replace as
necessary.
X
Main Applying And Wipe Down
Assembly
Remove Main Spring and check for any
restrictions when assembly is in motion
Worn bearings, bent
shafts, bent roller
arms
X
Knife Arm Assembly
Remove Knife Spring and check for any
restrictions when assembly is in motion
Worn bearings, bent
shafts, bent roller
arms
X
Frequency
Refer To Assembly Drawings For Part Numbers Of Replacement Parts If Required