IPG Interpack ET 2Plus H275, Operator'S Manual & Parts List

Page: 15 / 78

15
R00
S
ET
-U
P
P
ROCEDURES
W
ARNING
! T
URN OFF ELECTRICAL POWER SUPPLY AND DISCONNECT THE POWER CORD
FROM THE ELECTRICAL SUPPLY BEFORE BEGINNING TO WORK ON THE
T
APE
H
EADS OR TO LOAD TAPE
. I
F POWER CORDS ARE NOT DISCONNECTED
,
SEVERE INJURY TO PERSONNEL COULD RESULT
.
UUU
Mounting Adapters
ET 2Plus Tape Heads require Mounting Adapter Hardware to install in any case sealer or
case erector. If your Tape Heads are pre-installed in your Interpack or TUFflex case sealer or
case erector, you do not need to follow any instructions from this section. If your tape heads
will be installed in any other competitior machinery, please review these general guidelines
plus any additional instructions included with your ET 2Plus tape head.
Location Of Mounting Adapter Holes
Front Cover
Figure 7-1
Rear Cover
Figure 7-
2
Examples Of Mounting Hardware
There are numerous mounting holes on the
front and rear side plates of the tape head.
These are used to install various mounting
adaptors. Examples of these mounting
adapters are:
1. Internal and external threaded nuts
2. Mounting Bars
3. Threaded Spacers
Figure 7-3