IPG BETTER PACKAGES RSA 2024-WAT-EU, Manual

Page: 58 / 220

RSA2024-WAT-EU Preventive Maintenance
7-5
7.5 R
EMOVING THE
T
OP
T
APE
H
EAD
For cutter blade maintenance and replacement, removal of the tape heads is required for ease of access. Make
sure tape has been removed from the top tape head before attempting to remove them from machine.
1. Remove quick-disconnect from the top of tape head, (refer to Figure 7-7).
2. Disconnect electrical connection of tape head by unhinging and removing plug, (refer to Figure 7-8).
3. Turn off flow of water by turning valve until it is perpendicular to flow of water and remove quick-disconnect
to allow removal of water pot, (refer to Figure 7-9).
4. Remove water pot from tape head, (refer to Figure 7-10).
5. Pull hold-down plate upwards to allow for removal of tape head, (refer to Figure 7-11).
6. Pull tape head forward then up to remove from tape head box, (refer to Figure 7-12).
Figure 7-10 Remove Water Pot Figure 7-11 Pull Hold-down
Plate
Figure 7-9 Quick-disconnect
Figure 7-7 Quick-disconnect
Figure 7-8 Electrical Disconnect
Figure 7-12 Remove Tape
Head Box