Technical Documentation
opti-check
v2.8.2-K11
296/332
ipf electronic GmbH
Lüdenscheid, Germany
15.5 Process interface via Industrial Ethernet (device dependant)
It is possible to communicate with the Vision Sensor via various Industrial Ethernet protocols, such as
PROFINET using a PLC.
15.5.1 Mode of operation
The data transfer protocol is determined by the Industrial Ethernet specification.
The following data can be transmitted:
-
General control and status data (triggers, pass / fail, active job, etc.)
-
Result data (configuration in the case of job creation via the
Output process interface
)
-
Job parameters (configuration in the case of job creation via the
Input process interface
)
-
Additional trigger data
The data will be combined into logical groups. Data transmission of each group can be secured with a
handshake.
Mapping of the data in the PLC must be planned using the manufacturer-specific tool.
Undertake Configuration of the protocol to be used using the
Application Suite
. You can find the settings
options under:
Device
→
Device settings
→
Process interface
.
