MANUAL
• Subject to alteration! Version: 07.01.2022
ipf electronic gmbh
│
Rosmarter Allee 14
•
58762 Altena
• Germany
│
Tel +49 2351 9365-0 • [email protected] •
1
IN32E332-S
Inductive proximity switsch
IV56E205-S
Amplifier
VKC0E333-S
Cable socket
Installation of the sensor
•
is an inductive proximity switch for non-flush mounting. Due to its construction,
the device only detects metallic objects.
•
To achieve the nominal switching distance of 15mm (see technical data), must have the metal part
following properties:
Material:
ST37
Dimensions: 32mm x 32mm x 1mm
For other materials, the correction factors are listed in the technical data.
•
The switching distance may deviate from the nominal value by ±20% due to component tolerances.
•
Install the device in a way, that the plastic cap is not surrounded by metal. The lateral distance to metallic
objects must be at least 32mm.
•
To avoid damaging the threaded sleeve during assembly, the tightening torque must not exceed 150 Nm.
•
The device may be used in surroundings with temperatures up to 230°C.
Installation of the amplifier
•
is to be used for the operation of the sensor IN32E332-S in connection with the
cable socket VKC0E333-S.
•
The device is suitable for mounting on a DIN rail. Mounting must take place outside the dust-ex-area, e.g.
in a protected switch cabinet.
•
The pnp switching output can be further processed with a PLC. The switching output has a switch-on delay
of 100ms.
Elektrical connection
Connection of the sensor to the amplifier via the
VKC0E333-S cable socket:
Connection of the operating voltage and the switching
output to the amplifier.
IMPORTANT:
•
Switch off the operating voltage before connecting or disconnecting the amplifier!
•
The cable socket may also only be plugged in or unplugged from the sensor when it is de-energized. An
appropriate waiting time (>10s) must be observed before pulling off.
•
When plugging in the cable socket, make sure that, that it snaps securely into the connector of the sensor.
Clamp 4:
brown (sensor power 3V)
Clamp 5:
black (screen)
Clamp 6:
blue (sensor power supply GND)
Clamp 9:
+ U
B
Clamp 8:
switching output pnp, no, 400mA
Clamp 7:
0V (GND)
