iPECS eMG800
Hardware Description and Installation Manual
Issue 1.8
77
5.1.4
DSS/BLF Console Installation & Wiring
5.1.4.1
LDP-7048 DSS Installation & Wiring
The digital LDP-7048 DSS/BLF Console is provided with a phone-mounting bracket, used to fasten the
Console to the phone securely. To attach the fastener,
1)
Turn the Console and phone upside down,
2)
Place the fastener in position,
3)
Insert and tighten screws. Caution: do not over-tighten as this may damage the plastic phone
housing.
Figure 5.1.4.1-1 LDP-7048 Console Install
LDP-7048 DSS Console is wired as a normal Digital Key Telephone to a separate port of a DISU or DTIB,
refer to section 5.1.2.1.
5.1.4.2
LIP-8000 DSS Installation and Wiring
LIP-8000/8000E Series DSS/BLF Console is available in three (3) models 12 button w/paper labels (LIP-
8012DSS), 12-button w/LCD (LIP-8012LSS), and 48-button w/paper labels (LIP-8048DSS).
Up to four (4) consoles can be connected to LIP-8000/800E series phone using the serial ribbon cable from
the console.
LIP-8000 phones will power a maximum two (2) LCD DSS Consoles and, when more than two consoles are
connected, one must be the 48-button Console.
In all cases, the 48-button Console must be powered by the AC/DC Adaptor-K. The figures below depict
installation of various console configurations.
Note that in all cases, AC/DC Adaptor-K is attached to the 48-button Console.
Refer to install an LIP-8000 series DSS Console,
1)
Turn the LIP phone and DSS Console upside down.
2)
Remove the rubber plug in the LIP phone protecting the DSS serial cable connector.
3)
Insert the flat ribbon cable from the DSS Console into the connector in the LIP phone.
