iPECS eMG800
Hardware Description and Installation Manual
Issue 1.8
42
Refer to the pin-out chart and Figure 4.3.3.3-1 E1-PRIB Connector Wiring Diagram below,
Wire the TX and RX pins of the RJ45 connector to the digital line termination point using UTP cable.
Tag or number wiring for maintenance.
Table 4.3.3.3-1 PRI Port
CONNECTOR
PIN
SIGNAL
RJ45
1
RX+
2
RX-
4
TX+
5
TX-
3,6,7,8
Not used
Figure 4.3.3.3-1 E1-PRIB Connector Wiring Diagram
4.3.3.4
Serial Port
The PRIB includes an Audio jack connected to a Serial port. The serial port is used for diagnostic purposes.
For wiring information, refer to section 4.6.
