iPECS eMG800
Hardware Description and Installation Manual
Issue 1.8
26
4 BOARD INSTALLATION
4.1
General Board Install Procedure
Prior to installing the Boards, the following should be considered:
CAUTION
Verify the electrical Power is turned OFF before installation of boards.
To protect the System from static electricity, do not directly touch the boards to discharge static, touch
a grounded object, or wear a grounding strap.
To install the Board,
1)
If required, install any option modules on the board and set any switches.
2)
Slide the board along the guide rails into the KSU until the Board is securely seated in the
backplane connector.
3)
Press the thumbscrews in and turn clockwise to affix the Board securely.
4)
Wire the Board connectors as required.
Figure 4.1-1 Board Installation