ENGLISH
Squeegee installation and adjustment
Lower the squeegee using the lever (fig. 3-ref. 1).
Lift the squeegee fastening levers (fig. 3-ref. 3), insert the squeegee in the slots in the support (fig. 3-ref. 2), then lower the fastening levers (fig. 3-ref.
3) and insert the suction hose (fig. 3-ref. 4) in the squeegee.
Squeegee adjustment
The squeegee blades scrape the film of water and detergent from the floor and prepare the way for perfect drying. With time, the constant rubbing
makes the edge of the blade in contact with the floor rounded and cracked, reducing the drying efficiency and requiring it to be replaced. The state of
wear should be checked frequently.
For perfect drying, the squeegee must be adjusted in such a way that the edge of the rear blade bends during operation by about 45° with respect
to the floor at every point. The angle of the blades can be adjusted using the screw (fig. 3-ref. 5), while the height of the squeegee from the floor can
be adjusted using the knobs (fig. 4-ref. 6).
Brush installation
Automatic brush attachment, version “B”-“C”
(Fig.21):
raise the machine head by pushing the head lift pedal down and to the left, then using the operation selector, select the
Brush control, rest the brush on the floor in front of the machine and centre it with the head. Lower the head by pushing
the head lift pedal down and to the right and activate the drive lever momentarily; the brush will be attached automatically
to the hub on the flange. If the operation is not successful, repeat by pressing the lever again and repeating the centring.
Use of abrasive/microfibre disks: fit the abrasive/microfibre disk on the drive disk and perform the operations described
for fitting the brush on the scrubber drier.
Automatic brush attachment, version “BT”
(Fig.21):
raise the machine head by pushing the head lift pedal down and to the left, then using the operation selector, select the
Brush control, rest the brush on the floor in front of the machine and centre it with the head. Lower the head by pushing
the head lift pedal down and to the right, turn the selector to the “OFF” position, press the “SET” button once then press
the “+” button, the machine will complete the attachment sequence. Use of abrasive/microfibre disks: fit the abrasive/
microfibre disk on the drive disk and perform the operations described for fitting the brush on the scrubber drier.
Automatic brush attachment, version “XP”
:
position the brush underneath the head, turn the selector to the “OFF” position, press the “SET” button once then press
the “+” button, the machine will complete the brush attachment sequence.
Automatic brush release, version “B-BT”
(Fig.21): raise the machine head by pushing the head lift pedal down and
to the left, turn the selector to the “OFF” position, press the “SET” button once then press the “-” button, the machine will
complete the release sequence.
Automatic brush release, version “XP”:
turn the selector to the “OFF” position, press the “SET” button once then press the “-” button, the machine will complete
the release sequence.
Brush release, version ”C”
raise the machine head by pushing the head lift pedal down and to the left, then using the operation selector, select the Brush control and engage the
drive lever for 4 seconds; on releasing the lever, the machine will release the brush automatically.
A
6
4
21
1
2
3
4
5
6
3
13
