7.
Align the groove in the ADAC/5500 Series board’s PCI edge-connector with the ridge of the desired PCI slot.
See preceding right-hand figure.
8.
Push the board firmly into the PCI slot. The board should “snap” into position.
9.
Secure the board by inserting the rear-panel adapter-plate screw.
10.
Using the previous steps, install additional boards into available PCI bus-slots, if applicable to your application.
11.
Replace the computer’s cover.
12.
Plug in all cords and cables that were removed in step 1.
13.
Apply power to, and start up the PC.
Note
: At this point some PCs may prompt you to insert an installation disk. While this is rare, if you do receive
such a prompt simply place the install CD-ROM into the disk drive and follow additional screen prompts.
Reference Notes
:
After you have completed the installation you should refer to the electronic documents that were
automatically installed onto your hard drive as a part of product support. The default location is in the
Programs
group, which can be accessed from the Windows Desktop.
ADAC related documents, in Adobe® PDF format, are:
É
É
É
É
É
ADAC/5500 Series User’s Manual, p/n 1107-0905
(ADAC5500 Series Users Manual.pdf)
ADAC-LVi User’s Manual, Data Acquisition VIs for LabView, p/n 1107-0901
(ADAC-LVi Users Manual.pdf)
ADLIB WIN Interface Library Software User’s Manual, p/n 1107-0902
(ADLIB WIN Users Manual.pdf)
TP ADAC-32 (32-Bit TestPoint Driver) User’s Manual, p/n 1107-0903
(TP ADAC-32 Users Manual.pdf)
PlotterX, PlotterX Plus, and ADAC Config Getting Started, p/n 1107-0941
(PlotterX-GettingStarted.pdf)
8 ADAC/5500 Series Installation Guide
908096
1107-0940, rev 2.0
