background image

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed, including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

  1. 

CAUTION 

– To prevent electrical shock, do not mate unit connector until installation is complete and A.C. 

power is supplied to the unit.

  2. 

CAUTION 

– This fixture provides more than one power supply output source. To reduce the risk of electrical 

shock, disconnect both normal and emergency sources by turning off the A.C. branch circuit and by discon-

necting the unit connector.

  3. 

CAUTION 

– This is a sealed unit. The integral, high temperature Ni-Cad battery is not replaceable. Replace 

the entire unit when necessary and recycle or dispose of the nickel-cadmium battery properly.

  4. 

DO NOT USE OUTDOORS.

 The 

I-42-EM-B

 is for use with grounded, UL Listed, indoor fixtures except in 

heated air outlets or hazardous locations.

  5.  The 

I-42-EM-B

 requires an unswitched A.C. power source of either 120 or 277 volts. Properly cap the unused 

A.C. lead.

  6. 

The 

I-42-EM-B

 and A.C. ballast 

must

 be on the same branch circuit.

 

 

  7.  Do not mount near gas or electric heaters.

 8.   The 

I-42-EM-B

 should be mounted in locations and at heights where it will not readily be subjected to tamper-

ing by unauthorized personnel.

  9.  The 

I-42-EM-B

 will cold strike and operate 

one

 10W through 42W, or 

two

 10W through 18W, 4 pin Rapid Start 

compact fluorescent lamps. Contact customer service for additional lamp usage.

 10.  The 

I-42-EM-B

 is compatible with most electronic A.C. ballasts (including multiple lamps) as follows: 

  Electronic ballasts – one or two lamp emergency operation.

 11.  The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.

 12.  Do not use this equipment for other than intended use.

 13.  Install in accordance with the National Electrical Code and local regulations.

 14.  Installation and servicing should be performed by qualified personnel.

15.  Lighting fixture manufacturers, electricians and end users need to ensure product system compatibility before 

final installation.

I-42-EM-B

INSTRUCTION MANUAL

TBTS SERIES AC

10W–42W RAPID START

4 PIN COMPACT LAMP

EMERgENCY LIghTINg EqUIPMENT

THIS UNIT CONTAINS A 

RECHARGEABLE NICKEL- 

CADMIUM BATTERY. PLEASE 

RECYCLE OR DISPOSE OF 

PROPERLY.

Reviews: