TIGER Select Instrument User Manual V3.2
Unrivalled Gas Detect
ion.
Page 15 of 73
ionscience.com
3.
Getting Started
Fitting the Inlet Probe
Ensure that the inlet probe supplied is fitted to your TIGER Select.
Switching your TIGER Select On
Press the
Enter / On / Off
key once to turn TIGER Select On
.
The lights will flash white, red, then amber,
and a “beep” will sound. You should also be able to hear
the pump start operating.
The display will initially show the ION Science logo. It will then display a screen showing the ID of the
instrument, as entered in the Instrument ID in TigerPC, and the firmware version installed on it.
The display will then show the instrument checking that the Lamp is working (the
symbol is
displayed).
if the instrument is set to Zero when switched on
, the screen will display the
symbol.
The main running screen is then displayed:
Your instrument is now ready to use.
Switching your TIGER Select Off
Press and hold the
Enter / On / Off
key for 3 seconds to turn TIGER Select Off. A 3 second
countdown will be displayed on the screen. While this is happening, a continuous beep will sound,
and the lights will flash red.
Once the instrument is switched off, wait a few seconds before switching on again.
Checking the Battery Charge
Check that your TIGER Select has sufficient charge for use. The battery icon (see
) should
show at least two full segments. If not, the instrument should be charged to at least this level before
use.
