Ion Technologies Sumpro
®
Battery Back-Up
OPERATION MANUAL
Dated: 08/18/2017
Document Name: SUMPRO_100_OM
Page 1 of 12
www.ionproducts.net
Introduction
Reasonable care and safe methods should be
practiced. Check local codes and requirements
before installation. This manual contains important
information for the safe use of this product. Read
this manual completely before using this product and
refer to it often for continued safe product use.
Note:
This manual covers the installation of the
inverter, regardless of what pump, switch or
controller combination is included in the system you
purchased. For more detailed installation information
and troubleshooting regarding the pump, switch or
controller, please refer to their individual manuals.
DO NOT THROW AWAY OR LOSE THIS MANUAL.
Keep it in a safe place so that you may refer to it when
needed.
Warning
WARNING:
Always disconnect the Unit from
the receptacle power source and battery
before handling or making any adjustments to the
system.
Battery Backup Warning:
1. Risk of electrical shock this Unit has not been
investigated for use in outdoor areas.
2. Risk of electrical shock. Connect only to a
properly grounded, three pronged grounding
type receptacle. Under any circumstances,
do not remove the grounding prong from the
power cord.
3. Do not smoke, use sparkable electrical devices
or open flame when working on this unit!
4.
Do not install Unit in locations classified as
hazardous per N.E.C., ANSI/NFPA 70 - 2014.
FAILURE TO HEED ABOVE CAUTIONS
COULD RESULT IN INJURY OR DEATH.
The Sumpro® is designed to operate a load up to
12 Amps. If operating more than one pump, the
combined FLA cannot exceed 12 Amps.
Important Safety Instructions
Before proceeding further, please review the safety
instructions carefully.
General Precautions:
• Before using the inverter read all instructions
and caution markings on the inverter, the
batteries & all appropriate sections of this
instruction manual.
• Do not expose the inverter to any type of
chemicals. The inverter is designed for interior
use only.
• Do not disassemble the inverter; contact
Metropolitan Industries Wholesale Customer
Support at (800) 323-1665 when service or
repair is required. Opening by unqualified
personnel can lead to electrical shock or fire
hazard and void the warranty.
• To reduce risk of electric shock, disconnect all
wiring before cleaning.
WARNING:
Avoid exposing the inverter or
batteries to any type of explosive gases, as
batteries generate explosive gases during normal
operation. Install the batteries in a well ventilated
area.
To reduce the risk of battery explosion, follow all the
instructions of the battery supplier or any equipment
you intend to use in the vicinity of batteries.
