IOGear GBB1000N, User Manual

Page: 27 / 52

27
LCD/Button Operations
Button Operation
ON / MUTE

SELECT

OFF / ENTER 

ON / MUTE

SELECT

OFF / ENTER 

IOGEAR UPS includes an LCD display with a
3-button configuration interface
Button Function
On / Mute Button • Turning the UPS On: Press and hold ON/Mute button for at
least 2 seconds
• Mute the Alarm: After the UPS is ON in battery mode, press
and hold this button for at least 3 seconds to disable or enable
the alarm system. However, this is not applied to situations
when warnings or errors occur
• Up Key: Press this button to display previous selection in UPS
setting mode
• Switch to UPS self-test mode: Press ON/Mute button for 2 sec-
onds to enter UPS self-testing while in AC mode, ECO mode or
Converter Mode
OFF / Enter Button • Turning the UPS Off: Press and hold Off / Enter button for at
least 2 seconds. UPS will be in standby mode under normal
power or transfer to Bypass Mode if the Bypass setting is
enabled
• Confirm Selection Key: Press this button to confirm selection in
UPS setting mode
Select Button • Switch LCD message: Press this button to change the LCD
message for input voltage, input frequency, input current,
battery voltage, battery current, battery capacity, ambient
temperature, output voltage, output frequency, load current and
load percent
• Setting Mode: Press and hold this button for 3 seconds to enter
UPS setting mode when on Standby and Bypass mode
• Down Key: Press this button to display next selection in UPS
Setting Mode