ICA100-02 IoT Data Transmission Terminal
Operation guide
-6-
3 Operation guide
3.1 Operation description
Equipment required: Networked computer, WIFI data transmission terminal.
3.1.1 WIFI configuration procedure
1.
Connect the power cable and WIFI antenna based on the port description and power on
the WIFI data transmission terminal. If the NET yellow indicator is ON in AP mode, a
hotspot has been created on the WIFI module.
2.
Download the iWoStudio software from the official website and install it on your laptop.
3.
In the bottom right corner of your desktop, click the network button to select the WIFI
hotspot corresponding to the WIFI module in the wireless network list.
Note:
The name of the WIFI hotspot is the serial number on the barcode, and the
password is "00 + the secret key on the barcode".
4.
Start the iWoStudio software and go to the WIFI card configuration page. Select or enter
the router WIFI name, enter the password, and click
Config
.
5.
WIFI data transmission terminal is switched to the STA mode after the configuration. The
network connection status can be viewed by the NET indicator.
Note:
To make changes to the configuration, press and hold the RESET button for more
than 6s to restore to the default settings and configure again.
3.1.2 IoT monitoring procedure
1.
Record the device ID and 6-digit key from the label and add them to the IoT monitoring
system (website: https://iot.invt.com/login).
2.
Connect the power cable, RS485 communication cable, and WIFI antenna based on the
port description.
3.
Configure the WIFI module, power on and start the WIFI data transmission terminal.