Goodrive350-19 series VFD Commissioning
- 51 -
5.4.4 Points for attention
If you only want to check whether the VFD runs properly, set P90.00=0(Common mode).
If you perform empty-load commissioning, set P90.00 to 4 (Tower crane rotating function macro),
and set P11.08 to 0x000 to disable underload protection.
During onsite commissioning, if the VFD terminal signal forward/reverse running command is
inconsistent with the load running direction, adjust any two phase sequences of VFD output
terminals U, V, and W.
This macro can meet the requirements of most tower crane rotating application cases, and the
performance parameters have been optimized and do not need to be adjusted in most cases. If
an exception occurs, see the function parameter chapter for adjustment or contact the technical
support.
5.5 Commissioning the conical motor function
5.5.1 Wiring
(+)
PB
GD350-19 VFD
R
S
T
R
S
T
M
3~
U
V
W
PE
S1
S2
S3
S4
HDIA
VFD fault
output
RO1A
RO1B
RO1C
FWD
REV
Multi-step setting terminal 1
Coasting to stop
Fault reset
Braking resistor
COM
PW
+24V
Figure 5.5 Wiring for the conical motor
Note:
If the wiring is performed according to Figure 5.5, most VFD parameters need no adjustment. If
the onsite function terminals are inconsistent with the terminals shown in the figure, adjust the input
and output terminal functions according to the actual wiring after selecting the conical motor
application macro.
5.5.2 Commissioning procedure
1. Check the wiring and ensure the wiring is proper.
2. Set P00.18=1.
3. Set motor nameplate parameters in P02.
