Goodrive350 IP55 High-ingress Protection Series VFD
Basic Operation Instructions
-41-
save the selected parameter and return to the previous menu. In parameter selection edit
interface, press
key to maintain the parameter value and return to the previous menu.
Figure 5-15 Editing user defined parameters
Present: 0
Auth:
√
0
：
SVC0
1
：
SVC1
2
：
SVPWM
Present: 1
Auth:
√
1
：
SVC 1
2
：
SVPWM
3
：
VC
Default: 2
Default: 2
GD350
16:02:35
P00.00: Speed Ctrl Run Cmd
P00.02: Comm Cmd Channel
P00.03: Max Output Freq
P00.04: RunFreq Up Limit
P00.05: RunFreq Low Limit
Fwd
Local
Ready
P00.01: Run Cmd Channel
3
：
VC
Note: If 0/1/3 is selected, it is required to set motor
nameplate parameters first and perform motor
parameter autotuning.
Note: If 0/1/3 is selected, it is required to set motor
nameplate parameters first and perform motor
parameter autotuning.
Back Edit Sele
Back Home OK
Back Home OK
In parameter selection edit interface, the "Auth" on the top right indicates whether this
parameter is editable or not.
"
√
" indicates the set value of this parameter can be modified under current state.
"×" indicates the set value of this parameter cannot be modified under current state.
"Present" indicates the present value.
"Default" indicates the default value of this parameter.
5.4.6 Editing parameters in parameter groups
You can choose Menu > Parameter groups, enter a specific function group and then a specific
function code, and then press
key,
key or
key to enter the parameter setting
interface. After entering the edit interface, set the parameter from the low bit to high bit, and the
bit under setting will be highlighted. Press
key or
key to increase or decrease the
parameter value (this operation is valid until the parameter value exceeds the max. value or
min. value); press
or
to shift the edit bit. After the parameter is set, press
key or
key to save the setting and return to the previous menu; press
to maintain
the original parameter value and return to the previous menu.
Figure 5-16 Editing parameters in parameter groups
In parameter selection edit interface, the "Auth" on the top right indicates whether this
parameter can be modified or not.
"
√
" indicates the set value of this parameter can be modified under current state.
"×" indicates the set value of this parameter cannot be modified under current state.
"Present" indicates the present value.
"Default" indicates the default value of this parameter.
Max Output Freq Hz
050.0
0
Max : 630.00
Min : 50.00
Present
：
50.00
Auth:
√
Default : 50.00
Max Output Freq Hz
050.0
1
Max : 630.00
Min : 50.00
Present
：
50.00
Auth:
√
Default : 50.00
GD350
16:02:35
P00.00: Speed Ctrl Run Cmd
P00.02: Comm Cmd Channel
P00.04: RunFreq Up Limit
P00.05: RunFreq Low Limit
Fwd
Local
Ready
P00.01: Run Cmd Channel
P00.03: Max Output Freq
Back Edit Sele
Back Home OK
Back Home OK
