15
4.2 Timer Controller (D800):
Using their three buttons, you can adjust the strength of the snow, the ejection time and intervals, and adjust the
functions of the device optimally to the requirements of the user.
1.
DURATION
- Controller: this sets the duration of each snow output.
2.
INTERVAL
-
Controller: this sets the time intervals between the individual snow ejections.
3.
OUTPUT
-
Controller: this sets the amount of snow (0-100%).
4.
TIMER
-
Button: this activates the timer function.
5.
CONTINUOUS
-
Button: this activates continuous output.
6.
MANUAL
-
Button: if the button is pressed, all other settings are deactivated and maximum snow output is
generated.
4.3 Radio remote control (not included):
Your "Alpina1200DMX" can also be equipped with a radio remote control. This makes this cutting machine very
flexible.
Receiver (W-2): Sender (W-1):
Status-LED:
The status LED allows you to quickly see if your snow machine is ready to use.
If you want to use the radio remote control for your "Alpina1200DMX", please pull the antenna completely out to
ensure a secure connection. The remote has a maximum range of 30 - 50m outdoors. So you can use the
"Alpina1200DMX" ideally also for theater or presentation purposes.
Plug the radio receiver (W-2) into the 5-pin socket on the back of the unit (see section 4.1 housing parts). Place the
receiver so that free reception is guaranteed. Prevent the receiver from being obscured by other devices.
Otherwise, reception errors could occur. The receiver has a magnetic plate, which means that it can also be found
directly on the "Alpina1200DMX".
There are four dip switches on the side of the receiver. Set one of the four dip switches to the "ON" position. The
numbered button of the transmitter "W-1", which corresponds to the numbered Dip switch, controls the snow
1. 2.
3.
4. 5. 6.
