14
Part 4. Functions and operation:
4.1 Housing Back:
1. POWER:
IEC mains power input socket with fuse holder for F10A 250V fuse.
The assignment of the connection leads is as follows:
Line
Pin
International
Brown
Outer conductor
L
Blue
Neutral conductor
N
Yellow/Green
Earth conductor
The protective conductor must be connected!
IMPORTANT:
Replace the fuse only with a fuse of the same type and with the same values (printed on the device).
If the fuse is triggered repeatedly, please contact an authorized service center
.
2. Power switch:
ON
: Indicates that the unit is switched on.
OFF
: Indicates that the unit is switched off. The
mains switch switches off unipolar, so the mains plug must be disconnected before the housing is opened to avoid
electric shock.
3.
DMX IN:
3-pin male XLR connector for connecting a DMX controller (e.g., DMX mixer).
4.
DMX Out:
3-pin female XLR connector for forwarding the DMX control signal.
5.
On-Board Menue:
Displays the operating mode and the value of individual functions.
6. 5-pin remote control input
:
This input is used to connect the remote control unit (W-2) or the timer
controller (D-800).
7.
Switch
for selecting the output quantity (HIGH / LOW)
1.
2.
3.
4.
5.
6.
7.
