background image

For Research Use Only. Not for use in diagnostic procedures.

Mini Gel Tank

Cat. no.

 A25977

Publication Part No.

 

100025990  

Publication No. 

MAN0010862  

Rev. 

C.0

Instructions for using the Mini Gel Tank to perform electrophoresis are described below. For detailed instructions, refer to the  manual 

available  from thermofisher.com. See reverse side for protein transfer instructions using the Mini Blot Module.

Before Starting

•  Make sure that the power supply is adequate for the number of gels you are going to run.
•  If your power supply is not designed for use with covered or retractable power leads, 

make sure the power supply is off

, plug Novex

 

Power Supply Adapters into the appropriate leads of the power supply, and secure them with an Allen wrench (see manual for details).  

•  Select mini gels appropriate for your application.
•  Prepare 1X running buffer appropriate for your mini gels. Each chamber requires 400 mL of buffer.

Procedure

1.

 

 

Snap the electrophoresis tank into the  

 

base, and place the cassette clamp(s)  

 

into the chamber(s) with the

 

anode  

 

connector(s) (

+) 

aligned to the center. 

 

Fill the chamber(s) with 1X buffer to the  

 

level of the cathode.

4. 

 Make sure the wells are completely  

 

filled with 1X buffer.

 

Load your samples and markers.

2.

  

Remove the comb, and peel away the 

 

 

tape at the bottom of the gel cassette. 

 

Rinse the wells 3 times with 1X buffer.

5.

 

 

Hold the cassette and release the  

 

cassette clamp.

 

Gently lower the cassette so that it rests  

 

on the bottom of the chamber, and close  

 

the cassette clamp.

 

Add 1X buffer to the level of the fill line.

 

 

 

6

.

  

Make sure the power supply is 

off

.

   If only running one gel, remove  the  

 

cassette clamp from unused chamber.

 

Place the lid on the tank and plug the 

 

electrode cords into the power supply.

 

Turn the power supply on to begin  

 electrophoresis.

3.  

Place the cassette in the chamber with  

 

the wells facing towards you.

 

Hold the cassette in a raised position  

 

and close the clamp by moving the cam  

 

handle forward.

1

3

4

5

2

6

Cathode

Cathode

(+) Anode  connectors

Cam 

Handle

QUICK REFERENCE

Reviews: