Technical parameters
Inputs
4 x IF inputs from Quattro LNB
1 x UHF/VHF input from Terrestrial antenna
Outputs
4 x Loopthrough satellite IF outputs
1 x Loopthrough terrestrial output
1 x Legacy output to connect to legacy receiver with combined
terrestrial signal
1 x Unicable output to connect up to 4 receiver tuners with
combined terrestrial signal
Frequency range
Satellite: 950-2150MHz
Terrestrial: 47-862MHz
Loopthrough loss
Satellite: max 3dB
Terrestrial: max 3dB
Gain
Satellite: 10dB (min)
Terrestrial: no amplification
Isolation
Satellite-Satellite outputs: min 30dB
Satellite-Terrestrial : min 35dB
Control protocol
DiSEqC™ commands extension according to CENELEC
prEN50494
Power consumption
20VDC, 225mA
Dimensions (W x H x D mm)
W=88 H=120 D=35 mm
Temperature range
-20C - +60C
AC/DC adaptor
Input voltage: 100-240VAC, 50/60Hz
Output voltage: 19VDC
Output current: 940mA
Short circuit protection: Yes
Power Inserter
Input voltage: 20VDC
Output power: 20VDC, 500mA
Troubleshooting
Make sure the satellite antenna and LNB are properly fixed, connected and adjusted and that the satel-
lite receivers are installed, connected and switched on according to available instructions.
Ensure there is no short circuit on the product inputs. This will prevent power to the LNB. If this is the
case, disconnect the product from the main power, and then find and remove the short circuit on the
product inputs. Then re-connect the multiswitch to the main power. Frequent defects are in connector
joints i.e. if the central conductor is too short and fails to make contact in the connector. Also the shield-
ing braid should make proper contact with the connector coat. Sometimes a reset to the multiswitch
microprocessor is sufficient to remove a fault: simply disconnect the multiswitch from main power for 30
seconds and then reconnect again. If you are unable to remove the fault yourself, please contact your
distributor.
Disposal
Following relevant EU directives, this device shall not be disposed of together with municipal waste.
Use local waste collection and recycling systems to dispose wore out products.
*DiSEqC™ is a registered trademark of Eutelsat
*For purpose of brevity, some product descriptions in this sheet remain at platform level and may not
be referred to as detailed data-sheets of the products. Inverto Digital Labs reserves the right to amend,
omit or add products, product-lines, and/ or features without notice.
Installation manual
Unicable
™
Multiswitch
IDLP-UST1O1-CUO1O-4PP
4
V101
110
V/L
V/H
H/L
H/H
T er
res
tria
l
inp
ut
Sat
ellit
e - I
npu
t
H/H
H/L
V/H
V/L
Sat
ellit
e - l
oop
- th
rou
gh o
utp
ut
TM
Unicable Cascadable Switch
IDLP-UST1O1-CUO1O-4PP
Use
r Ban
ds:
0 : 1210MHz
1 : 1420MHz
2 : 1680MHz
3 : 2040MHz
Sat
elli
te i
npu
ts: I
F 95
0-2
15
0M
Hz
Sat
elli
te L
oop
-T
hro
ugh l
oss
: -3
dB
Ter
res
tria
l Loo
p-T
hro
ugh l
oss
: -3
dB
Unicable Out
Legacy Out
T er
res
tria
l
loo
p th
rou
gh
out
put
V/L
V/H
H/L
H/H
T er
res
tria
l
inp
ut
Sat
ellit
e - I
npu
t
H/H
H/L
V/H
V/L
Sat
ellit
e - l
oop
- th
rou
gh o
utp
ut
TM
Unicable Cascadable Switch
IDLP-UST1O1-CUO1O-4PP
Use
r Ban
ds:
0 : 1210MHz
1 : 1420MHz
2 : 1680MHz
3 : 2040MHz
Sat
elli
te i
npu
ts: I
F 95
0-2
15
0M
Hz
Sat
elli
te L
oop
-T
hro
ugh l
oss
: -3
dB
Ter
res
tria
l Loo
p-T
hro
ugh l
oss
: -3
dB
Unicable Out
Legacy Out
T er
res
tria
l
loo
p th
rou
gh
out
put
V/L
V/H
H/L
H/H
T er
res
tria
l
inp
ut
Sat
ellit
e - I
npu
t
H/H
H/L
V/H
V/L
Sat
ellit
e - l
oop
- th
rou
gh o
utp
ut
TM
Unicable Cascadable Switch
IDLP-UST1O1-CUO1O-4PP
Use
r Ban
ds:
0 : 1210MHz
1 : 1420MHz
2 : 1680MHz
3 : 2040MHz
Sat
elli
te i
npu
ts: I
F 95
0-2
15
0M
Hz
Sat
elli
te L
oop
-T
hro
ugh l
oss
: -3
dB
Ter
res
tria
l Loo
p-T
hro
ugh l
oss
: -3
dB
Unicable Out
Legacy Out
T er
res
tria
l
loo
p th
rou
gh
out
put
V/L
V/H
H/L
H/H
Terrestrial
input
Satellite - Input
H/H
H/L
V/H
V/L
Satellite - loop-through output
TM
Unicable cascadable switch
4 User Bands with combined Terrestrial input, 1 Legacy port
IDLP-UST1O1-CUO1O-4PP
User Bands:
0 : 1210MHz
1 : 1420MHz
2 : 1680MHz
3 : 2040MHz
Satellite inputs: IF 950-2150MHz
Satellite Loop-Through loss: -3dB
Terrestrial Loop-Through loss: -3dB
Unicable Out
Legacy Out
Terrestrial
loop through
output
