inveo IND2, User Manual

Page: 54 / 61

•
Log Card Action – setting up event logging during a valid connection to the
master – only for Card Action setting Reader card action → :
◦
As card action (if set) – log events according to Card Action settings,
◦
Omit log action – skip logging settings for Card Action.
•
Block RFID read – block the reading of the next tag:
◦
Block – when the RFID tag is read correctly, a value of 1 is written to Holding
Register 1. Only after the flag is reset will it be possible to read the next
transponder. (Set the Holding Register 1 register to the value 0).
◦
Continous – automatically clear the read flag, which enables the immediate
reading of the next RFID tags.
•
Safe mode – reader's reaction when modbus connection is broken:
◦
Disable ,
◦
No action – no reader response to a tag proximity, for a broken connection,
◦
Standalone (Reader Card Action) – switch to autonomous mode in case of
a broken connection.
•
Safe Timeout – time without connection after which the reader will switch to
Safe mode .
The device supports the following modbus functions:
•
0x01 Read Coils,
•
0x03 Read Holding Register,
•
0x05 Write Single Coil,
•
0x06 Write Single Register,
•
0x0F Write Multiple Coils,
•
0x10 Write Multiple Registers.
8.5.1 Addresses Holding Registers
Addr.# R/W Description
1 R/W Read flag
Read: 1 – a new transponder has been read
Write: 0 – reset the read flag
2 R ID_LEN
3 R UID/CSN [0]
4 R UID/CSN [1]
5 R UID/CSN [2]
6 R UID/CSN [3]
7 R UID/CSN [4]
8 R UID/CSN [5]
9 R UID/CSN [6]
10 R UID/CSN [7]
11 R UID/CSN [8]
12 R UID/CSN [9]
13 R Reserved
14 R User ID – value FFFF/65535 means tag unknown
20 R/W Control output #1 according to settings from the I/O Settings tab
21 W Control output #1 in bistable mode
22 W Activation of output #1 for time specified as parameter (value * 0.1 sec)
23 W Time blink_on (value * 0.1 sec)
User manual RFID IND2
Page
54
of
61
[B01]