inventum IPF1000R, User Manual

Page: 15 / 36

Installing the filter
1. Put the O-ring (A) on the extractor hood.
Warning:
Only install the adapter when the motor of the extractor hood is too close to the wall.
2. If necessary, put the adapter (B) and the O-ring (A) on the extractor hood.
3. Put the hose clamp (B) and the filter (A) on the extractor hood or the adapter.
4. Tighten the hose clamp.
Connecting the filter
1. Connect the extractor hood plug and the filter plug to the mains adapter.
2. Connect the mains adapter to the mains supply.
Finishing the installation
1. Install the shaft on the extractor hood.
2. Make sure that the shaft has sufficient openings for ventilation.
5 Operation
PREPARING FOR OPERATION
1. For optimal room air cleaning, it is imperative for your extractor hood to be adequately ventilated and adapted to
the respective steam development.
2. Make sure that you activate your extractor hood at level 1 or 2 at least 10 minutes before you start cooking.
COMPLETING OPERATION
1. Make sure that your extractor hood operates at level 1 or 2 for 15 minutes after you finish cooking.
6 Technical data
PRODUCT FICHE
Item Specification
Capacity 1000 m 3
Features
Suitable for all extractor hoods (new / pre-installed)
Cleaning the air and removing bad odours up to 98%
Long lifespan
Self cleaning
No ozone O
3
Double filter: plasma and carbon
Compliant to RoHS directive
Pressure loss 100 Pa per 2 m/s
Contact time / Inflow speed
depending on level of contamination
0.1-1 sec., max. 2 minutes
Noise level 0 dB
(Figure 4)
(Figure 5)
(Figure 6)
(Figure 7)
English • 15