cleaning and maintenance
5
We recommend cleaning the hot water dispenser regularly, e.g. once per month. This is not only beneficial for the life span of the
appliance, but also ensures optimum use and, of course, nice water.
Prior to cleaning, always remove the plug from the wall socket and allow the appliance to cool down.
CLEANING
Regularly wipe the outside with a moist cloth.
Never use detergents or abrasive cleaning agents!
Clean separate components such as the water reservoir, drip tray and cup grille with warm water and a mild washing-up liquid.
Dry these components thoroughly.
After cleaning the hot water dispenser, also remove any excess water via the water drain at the bottom.
Unscrew the rubber cap
[11]
of the water drain at the bottom of the appliance and allow the excess water
to run out of the appliance above the sink.
Properly re-tighten the rubber cap.
Attach the separate components and the appliance will be ready for use again.
REPLACING THE ANTI-SCALE FILTER
After every 150 litres of water, the anti-scale filter must be replaced. In case of moderate use, this will be approximately 3 times per
year. A new anti-scale filter is available via the Inventum webshop.
Open the lid
[a]
of the water reservoir
[b]
and remove the filter bucket
[c]
with the filter
[d]
. Remove the filter
[d]
from the filter
bucket and place a new filter. The old anti-scale filter can be disposed of. Place the filter bucket back in the water reservoir.
using the appliance
4
Check that the voltage stated on the information plate matches the voltage used in your region.
Place the appliance on a heat-resistant, flat surface. Insert the plug in an earthed wall socket.
FILLING THE HOT WATER DISPENSER
1. Open the lid of the water reservoir.
2. Lift the water reservoir from the appliance and use a measuring cup or bottle to fill the water reservoir.
3. Fill the water reservoir with maximum 2.2 litres of cold water.
4. Place the water reservoir back on the appliance and close the lid.
TAKING HOT WATER
1.
Place a glass or cup under the water outlet on the cup grille.
2.
Turn the temperature knob to the required temperature.
3.
Press the on/off button once.
4.
The hot water flows from the water outlet.
5.
Press the on/off button once more to stop the water flow.
6.
When filling several glasses, repeat the above steps.
Caution:
the water and steam are hot and could cause burns in case of contact with your skin.
aan
uit
85 C
100 C
65 C
50 C
35 C
a
b
c
d
11
12
•
English
Summary of Contents for HWD722
Page 2: ...2...
