inventum AKD9015GTZ, User Manual

Page: 31 / 76

• Attention:
The carbon filters and plasma filters are not included. You need to order these separately.
EXTRA FUNCTION
Refresh control
During the refresh control function, the appliance goes on every 10 minutes on the lowest speed to refresh the air in
the kitchen / room. After 24 hours the refresh control function stops automatically.
4 Installation
SAFETY INSTRUCTIONS FOR INSTALLATION
• Install the appliance with two people.
• Wear safety gloves. The appliance has sharp edges.
• The distance between the lowest point of the appliance and a gas hob must be a minimum of 75 cm. For an
electrical, ceramic or induction hob, the minimum distance must be 65 cm.
• Always obey the manual of the cooker or the gas hob if that manual states a larger distance.
•
Warning:
• Risk of electric shock
• Always use the screws or fasteners that are stated in the installation instructions. Failure to do so
can result in electric shock.
UNPACKING
1. Remove the packaging.
2. Examine the appliance for damage.
3. Make sure that the voltage is the same as on the type plate.
PREPARING FOR INSTALLATION
1. Mark the wall from the middle of the hob. Make sure that you keep the minimum distance
between the hob and the appliance into account (D1 or D2) plus the height of the appliance (B).
Note:
Use dimension D1 for a gas hob and dimension D2 for an electrical, ceramic or
induction hob.
2. Mark the position for the screws for the cooker hood according to the dimension (A).
Note:
The support for the shaft determines the height of the shaft. The openings in the support align with
the openings in the shaft.
3. Hold the support for the shaft at the desired height.
4. Mark the position for the openings.
INSTALLING THE SCREWS AND THE SUPPORT
Preliminary requirements
• Plugs Ø 8 mm x 40 mm (4x)
• Screws Ø 4.5 mm x 50 mm (4x)
(Figure 4)
English • 31