inventum AKB9015ZWA, User Manual

Page: 34 / 76

Caution:
Make sure that the appliance is off and that the mains plug is removed from the mains socket.
Caution:
Do not use abrasive cleaning agents or cleaning agents that contain alcohol.
CLEANING THE APPLIANCE
1. Clean the inside and the outside of the appliance. Use hot water and a mild cleaning agent.
2. Clean the control panel of the appliance. Use a damp cloth.
CLEANING THE GREASE FILTER
Note:
The grease filter must be cleaned when the display shows F (after 220 hours of operation).
1. Push the latch (A).
2. Support the grease filter (B) and remove it from the appliance.
3. Clean the grease filter. Use hot water and a mild cleaning agent.
4. If necessary, clean the grease filter in a dishwasher. Use a program with a low temperature.
Note:
The grease filter can change color after cleaning. This is normal.
5. Make sure that the grease filter is dry before installing.
REPLACING THE CARBON FILTER (OPTIONAL)
Note:
The grease filter must be replaced when the display shows C (after 100 hours of operation) or every 4
months.
Note:
This procedure is only valid if you installed the carbon filter with your appliance.
1. Remove the grease filter.
2. Replace the carbon filter (A) on the grease filter (B).
3. Install the grease filter.
REPLACING THE LAMP
Note:
This appliance is equipped with LED light strips. They can be used for a long time. In case a LED light
strip is blown, it must be replaced by a qualified person to avoid any hazard. Contact the Inventum
service department.
RESETTING A SATURATION INDICATOR
The control of the appliance occasionally shows an indicator on the display for certain cleaning and replacing
intervals.
1. Make sure that the appliance is switched off.
2. Touch the timer button for a few seconds to reset a saturation indicator.
(Figure 13)
(Figure 14)
34 • English