19
5.15.3 Enquiry of Outdoor Ambient Temperature
Under on or off state of the unit, press
Enter/Cancel
button for 5s, outdoor ambient temperature
will be displayed at temperature displaying location after a sound of click. This enquiry state will quit
by pressing any button. If there is not any operation for 20s, it will automatically quit.
Note:
1.
This function will be shielded after energized of 12hr for some models of the units without
outdoor ambient sensors. Please refer to Instruction for details.
2.
If malfunction of outdoor ambient sensor occurs, this function will be shielded in 12hr.
5.15.4 Selection of Centigrade and Fahrenheit
Under off state of the unit, press Mode and
▼
at the same time for 5s, the displayer panel will switch
between Centigrade and Fahrenheit.
5.15.5 Master/Slave Wired Controller Setting
Under the off status of the unit, press “Enter/cancel” and “Mode” at the same time for 5 seconds to
go to the master/slave wired controller setting interface, and then press
▲
or
▼
to make the adjustment.
In this case, only in the temperature display is there numbers displayed, 01 for the master wired
controller and 02 for the slave wired controller.
After that, press “Enter/cancel” to save the setting and quit this interface. If there is not any
operation in 20 seconds on this interface after the last button press, the system will quit automatically to
the normal off status without saving the current setting.
Note:
If there is only one wired controller, it only can be set as the master; otherwise the unit won’t run
normally
Summary of Contents for V1KI-09
Page 2: ......
Page 34: ...30 TIMER operation procedure Fig 27...
Page 36: ...32 How to insert batteries Fig 29...
Page 60: ...66129907237...
