4.10 Installing the inner cover panel
33
INSTALLATION AND ASSEMBLY
iV-Office ventilation device
•
Installation and operating instructions
CLICK
The inner cover panel is fitted.
TIP:
Ensure you install the dust filter properly
to avoid a malfunction of the ventilation device.
Requirements:
The thermal accumulator insert has been installed.
►
Insert the dust filter into the base plate.
Ensure
that the tab on the filter ring points
towards the interior and is located in the cut-out
provided in the base plate.
►
Ensure you push the filter ring firmly between the
fixing projections and the inner edge of the base plate.
►
Place the panel on the four spacers.
Ensure
that
the position arrows on the back of the panel are
pointing upwards. Check: The inVENTer logo
is located at the bottom right.
►
Press the detent lugs inwards on the spacers.
►
Slide the cover onto the spacers.
All spacers noticeably snap in.
Requirements:
You have completed the functional test.
►
Swap the positions of the white and the brown
cable with each other.
►
Push the connected inVENTron as far as the
thermal accumulator.
►
Set heat recovery operating mode (WRG)
on the controller.
(See the controller's installation and operating
instructions).
The fan is connected to the controller.
