34
Document Number
DCV-00214
Date Released
Mar. 2017
Revision Number/Security level
R00 S2
Retrofit G6+InvencoLink GVR Encore 500S (US) Installation Guide
8. Ease the top of the PPU panel forwards out of the dispenser door about an inch or so.
9. Remove the backing paper from each of the two MP0652 gaskets and apply them one to each
side of the top of the PPU panel as shown (only one side is shown):
10. Gently flex the center top of the PPU panel forward, so that the two top corners can be eased
back into place in the dispenser door without rubbing or otherwise damaging the gaskets just
installed. The gaskets will become slightly compressed when you release the flex on the panel.
11. Reinstall and tighten the seven screws removed in step 7.
12. From inside the dispenser door, apply an MP0651 gasket across the top of the PPU panel as
shown:
Note that the long part of the gasket goes on the back of the PPU panel, and the shorter part goes across
the top of the PPU panel, between the vertical edges of the dispenser door opening.
13. Acquire pre-assembled MZ0108 RFK Hatch Panel containing the G6 OPT.
Remove 7 screws
About 1/16”
Flush with this surface
