Scorpius
Service Manual
1654773~A
9
1.6 Self-Diagnostic Warning Light
When the main power switch is turned on, the self-diagnostic warning light will flash if there be any
malfunction or failure.
A u t o m a t i c V e r s i o n : s e l f - d i a g n o s t i c w a r n i n g l i g h t ,
s h a r e d w i t h t h e b a t t e r y i n d i c a t o r .
N o r m a l : r e m a i n s o n , a s d o e s t h e b a t t e r y p o w e r
i n d i c a t o r .
F a i l u r e : f l a s h e s a c c o r d i n g t o t h e n a t u r e o f t h e
f a i l u r e , s e e t h e t a b l e b e l o w .
M a n u a l V e r s i o n : s e l f - d i a g n o s t i c w a r n i n g l i g h t ,
s h a r e d w i t h t h e m a i n p o w e r l i g h t .
N o r m a l : c o n s t a n t g r e e n l i g h t .
F a i l u r e : f l a s h e s a c c o r d i n g t o t h e n a t u r e o f f a i l u r e ,
s e e t h e t a b l e b e l o w .
Number of
Flashes
Possible Cause
Handling Method
1
Battery Low
The batteries are running low.
•
Recharge the batteries.
2
Low Battery Fault
The batteries have run out of charge.
•
Recharge the batteries.
•
Check the battery and associated connections
and wiring.
3
High Battery Fault
Handling method:
1. Disconnect the battery pack and check the
battery condition.
2. SERVICE-6 Battery Pack Repair.
4
Current limit time-out or controller
overheat
Do not drive up steep slopes or overload the scooter.
5
N-D lever not set to D-position
Switch to D (drive) position. Turn off the power and
turn on again.
Electromagnetic brake failure
SERVICE-13-5 Electromagnetic Brake Repair.
6
The throttle is not in Neutral or the
folding/ unfolding procedure is
uncompleted.
Solution:
Repeat the folding or unfolding procedure.
SERVICE-1-3 Starter VR Repair.
The folding/ unfolding procedure is
uncompleted
Repeat the folding or unfolding procedure.
Scooter battery is being charged
Turn off the main power and disconnect the charger.
Micro switch failure
SERVICE-12-1 Micro Switch Repair.
7
Speed pot
SERVICE-1 Steering Shroud Repair.
8
Motor or relevant circuit failure
Solution:
SERVICE-11-1 DR Controller Repair
SERVICE-13-4 Motor Repair
9
Main cable, controller failure or
controller temperature too high
Solution:
SERVICE-11-1 DR Controller Repair
SERVICE-2-1 Main Cable Repair
