Scorpius
Service Manual
1654773~A
56
2.13.6 SERVICE-13-6 Sliding Base Repair
SERVICE-13-1 Solenoid Valve Repair
and
Folding Unit Repair (Manual Only)
1. Remove the two screws in the middle of the frame.
2. Take out the U-shaped fixing plate.
3. Remove the screws under the linear actuator (gas spring for the manual version).
4. Use an Allen driver (#6) to hold the hex screws, and turn the quick-release nut by hand for removal.
5. Take out the sliding base.
6. At this stage the rear frame is completely removable and could be replaced during this operation.
❖
When replacing the unit, follow the exact sequence of steps in reverse.
❖
For linear actuator repair, please refer to
❖
For repair of the gas spring, please refer to
SERVICE-13-8 Gas Spring Repair (Manual Version Only)
•
When reinstalling the electromagnetic brake device, make sure that the lever is in the right
place, to the rear, before fastening the four screws that hold it in place.
•
Step 3. When removing the electromagnetic brake, be careful not to pull, or put any force, on
the motor cable which would disturb the connections.
