Invacare rea Focus, User Manual

Page: 11 / 48

Components
4.2.2 Biangular backrest
A
C
1. Loosen the screws
A
.
2. Adjust the backrest to the desired position.
3. Re-tighten the screws
A
.
When the backrest is adjusted in height, the lower
Velcro® straps might need to be adjusted.
4. If needed, fold down the Velcro® upholstery and remove the
unnecessary straps.
The bottom Velcro® strap must be pulled through
the slot at the front of the backrest attachment
C . It
prevents the upholstery from sliding upwards.
4.2.3 Reclining backrest
WARNING!
Risk of injury
The backrest is not secured
–
The reclining backrest has two safety clamps which will
secure the backrest to the backrest tubes. Make sure
that the backrest is secured in its position and that the
safety clamps are secured after each adjustment.
1.
A
B
A
B
Reclining backrest without
gas spring
Reclining backrest with
gas spring
Release the two safety clamps
A
from the backrest tubes.
2.
B
Release the two top attachments B from the backrest tubes.
3.
C
Adjust to the desired height by sliding the backrest
C
up or
down on the backrest tubes.
•
The reclining backrest without gas spring can be adjusted in
three fixed positions (0, 40 and 80 mm)
•
The reclining backrest with gas spring can be adjusted in two
fixed positions (0 + 40 mm).
1431580-B 11