Invacare® Ultra Low Maxx by Motion Concepts
1.
Remove screws and washers
A
.
2.
Adjust thick 6.35 mm (0.25”) washer inside backrest
tube to top hole. Align with top hole of pushbar. See
detail in graphic.
3.
Insert screws and washers and tighten.
Adjusting backrest angle to 30° precline
Tools:
•
5 mm Allen key
•
6 mm Allen key
•
10 mm wrench
•
13 mm wrench
1.
Remove screws and washers
A
.
2.
Adjust thick 6.35 mm (0.25”) washer inside backrest
tube to bottom hole. Align with bottom hole of
pushbar. See detail in graphic.
3.
Insert screws and washers and tighten.
4.
Remove screws, washers and nuts
A
.
5.
Replace ESR crankarm
B
with precline ESR crankarm.
6.
Insert screws, washers and nuts and tighten.
8.12 Adjusting Angle of Preset Backrest
•
10 mm wrench
•
13 mm wrench
1.
On both sides, loosen screw
A
.
Do not remove it.
2.
On both sides, loosen and remove screw and washer
B
.
3.
Adjust backrest to desired angle.
4.
Insert screw and washer and tighten.
8.13 Adjusting foam inserts of High
Back
You can adjust the foam inserts on the High Back backrest
to give you more lateral and lumbar support.
1.
Remove cover
A
from backrest.
2.
Adjust lateral
B
and/or lumbar
C
insert to your needs.
3.
Reattach cover.
54
1586649-F
Summary of Contents for Motion Concepts Ultra Low Maxx
