Part No 1176089
9
Invacare® Matrx® PB Elite
Installing the Back
1.
Verify that the overall fit and alignment of the
back is correct (make adjustments as needed).
2.
Fully secure the cane clamp screws onto both
back posts, and tighten the set screws to ensure
the mounting plates do not slip or rotate.
3.
To best determine the optimal depth and recline
settings for the back, the user should be seated
in the wheelchair. While seated, loosen the
depth/recline screws on the mounting plates and
adjust the back to the desired depth and recline
angle. Re-tighten all screws to lock the back in
position.
4 Usage
4.1
Disengaging the Back from the Wheelchair
1.
Perform one of the following:
•
No Cord Release Mechanism -
Simultaneously lift the release levers
(left and right) to unlock the latch
mechanism and release the upper pins
from the mounting plates. Refer to the
figure.
•
Cord Release Mechanism - Lift cord
upward to unlock/open the release
levers. Refer to One-Hand Cord
Release Mechanism on page 10.
2.
Lift entire backrest up and forward to disengage
the lower pins from the lower slots in the
mounting plates.
Ensure that the depth/recline
adjustment for the back is made
symmetrically* on the left and right
mounting plates.
The vertical score lines on the mounting
plates are designed as a point of
reference to assist with symmetrical
mounting (see image). Since the back
can be mounted in a rotated (reclined)
position if desired, it will not always be
mounted parallel with these vertical
lines.
.
*Use score
lines to make
symmetrical
adjustments
on the left
and right
mounting
plates.
Score
Lines
Depth/Recline Screws
2
1
Upper Mounting Pin
Lower
Mounting
Pin
Release
Lever
