7.29.2
Installing the Headrest
1.
Make sure thumb screw
A
is loose.
2.
Install the headrest mounting tube
B
until the headrest stop
D
sits on the headrest mounting bracket
C
.
3.
If necessary, adjust the height, depth or direction of the headrest.
7.29.3
Adjusting Headrest Height
1.
Loosen the set screw
E
on the headrest stop.
2.
Loosen, but DO NOT remove, the thumb screw
A
that secures
the headrest mounting tube
B
to the headrest mounting bracket
C
.
3.
Position the headrest to the desired height.
4.
Tighten the thumb screw that secures the headrest to the
headrest mounting bracket.
5.
Tighten the set screw on the headrest stop.
6.
If necessary, adjust the depth or direction of the headrest.
7.29.4
Adjusting Headrest Depth/Direction
1.
Loosen, but DO NOT remove, the three socket screws
F
that
secure the offset fixture
G
to the slide tube
H
.
2.
If necessary, reposition the headrest to the desired depth by
sliding the headrest towards the front of the wheelchair or
towards the rear of the wheelchair.
3.
If necessary, reposition the headrest to the desired position
(headrest will move in any direction).
4.
While holding the headrest in the desired position, securely
tighten the three socket screws.
5.
If necessary, adjust the height of the headrest.
7.30
Replacing Headrest
Only one of two styles of headrests shown for clarity. Both
styles of headrest attach the same way.
1.
Remove the three socket screws
A
that secure the headrest
B
to the headrest mounting bracket
C
.
2.
Position the new headrest on the headrest mounting bracket and
secure with the existing three socket screws.
3.
If necessary, adjust the height, depth or direction of the headrest.
7.31
About Batteries
This section contains information on batteries used on the TDX SP
with elevate. For batteries on other wheelchairs equipped with a
Formula CG powered seating system refer to base owner’s manual
shipped with wheelchair.
1143155-R-01
71
Summary of Contents for Formula CG Elevate
Page 95: ...Notes...
