Fig. 5-20
1.
Loosen hand screw
A
.
2.
Adjust component to desired position.
3.
Tighten hand screw.
5.10.3 Adjusting Cheek Supports
Fig. 5-21
1.
Push components inwards or pull components out to
desired position.
5.11 Adjusting Elan Headrest
The headrest clamp hardware is designed to install into
existing mounting holes in the backrest pan.
CAUTION!
Risk of injury during use of the mobility device
as a vehicle seat if a headrest is wrongly
adjusted or not installed
This can cause the neck to be hyperextended
during collisions.
– A headrest must be installed. The headrest
optionally supplied for this mobility device by
Invacare is perfectly suitable for use during
transport.
– The headrest must be adjusted to the user's
ear height.
Fig. 5-22
1541361-N
49