5.
Fig. 6-29
When installing engaging turn knob (5) make sure that position (6) is correct.
6.
Fig. 6-30
Tighten bolt (7).
7.
Fig. 6-31
Check that engaging turn knob can be turned to "push" position (clockwise) and "drive" position (counterclockwise).
6.9.5 Replacing Castor Fork
Various forks can be installed to the mobility device. The following instructions show a single-sided fork as an example. The
course of action is the same for other variants.
•
19 mm wrench
•
Torque wrench
•
Oblong wooden block (at least 14 cm x 14 cm x 30 cm)
•
Parallel pin punches (6/8)
•
Hammer (300 g - 500 g)
1654647-B
41
