Wheelbase
Recommended Seat Depth
1
Narrow
Base
Wide
Base
460 mm
405 mm -- 455 mm
A
N/A
490 mm
455 mm -- 480 mm
B
A
520 mm
480 mm -- 505 mm
C
B
550 mm
505 mm -- 580 mm
N/A
C
•
5 mm Allen key
•
6 mm Allen key
•
Oblong wooden block (at least 7 cm x 7 cm x 30 cm)
1.
Place wooden block underneath mobility device next to
power module and prop up mobility device.
2.
Remove batteries. See
3.
Loosen and remove all screws
F
on both sides.
4.
Loosen and remove screw
D
and washer
E
on both
sides.
5.
Move main frame
G
to desired position (
A
,
B
or
C
).
Fig. 6-18
6.
Install parts in reverse order.
7.
Adjust seat depth to meet requirements of user. See
user manual.
8.
Test all functions.
6.8.2 Replacing Kerb Climber
CAUTION!
Risk of crushing
Injury hazard to hands. The gas spring is under pressure.
– Be careful with your hands.
– Use suitable tools.
•
5 mm Allen key
•
10 mm wrench
When removing, take care of small parts such as screws and washers. Put all small parts down so that they can
be installed in correct sequence.
1.
Standard values. Individual values depend on configuration of seating system.
1654647-B
33
