Invacare Aquatec Ocean Ergo, User Manual

Page: 17 / 224

Setup
4.2.6 Installing/Removing self-propelling wheels (optional)
IMPORTANT!
– When the self-propelling wheels are fitted, the
rear castors must remain locked.
– The hubs and the parking brakes for the
self-propelling wheels must be fitted by a
qualified technician. Assembly is described in
the assembly instructions “Aquatec® Ocean
Accessory – 24" wheels / Parking brake“.
1. Align all four castors in the driving direction.
2. Lock all castors.
3. Push the axle
D
on the self-propelling wheel inwards.
(The handrims project outwards.)
4. Press and hold the button F on the outside of the axle.
This releases the retaining balls C at the end of the axle.
5. Raise the shower and toilet chair slightly.
6. Insert the axle into the hub B and push in the
self-propelling wheel onto the axle until the end stop E .
7. Release the button F .
8. Check that the retaining balls are behind the hex nut A .
9. The assembly is the same for the right and left
self-propelling wheel.
To remove the wheels, carry out the same procedure in
the reverse order.
1639501-C
17