Invacare Alegio NG, User Manual

Page: 10 / 108

Invacare® Alegio NG
In order to prevent the cables from being damaged when
activating the motors, follow the instructions below.
1. Route the head section motor cable under the control
box, over the shear arm assembly cross tube and into
the hook on the mattress support cross tube.
2.
Route the cable under the head section motor housing.
3. Plug cable into motor and secure with locking clip.
4.
Verify the mains cable strain relief is attached to the
shear arm assembly.
3.6 Installing bed ends
Allen key
3.6.1 Bed end brackets
Depending on the bed end to be mounted, it might be
required to pre-mount or change the bed end brackets.
Mounting
1. Insert the bed end brackets into the side tubes of the
mattress support platform.
2. Fix the bed end brackets on the side tubes with the
screws from below and tighten firmly.
Dismounting
1. Remove the screws and pull the bed end brackets out of
the side tubes.
3.6.2 Bed ends with U-bracket style fitting
Mounting
1. Lower the bed end into the U-bracket fitting.
2. Press down firmly and ensure the bed end is fully seated
at the bottom of the U-bracket fitting.
Dismounting
1. Hold the bed end firmly on each side and pull up
vertically on both sides at the same time.
3.6.3 Bed ends with Sanne style fitting
CAUTION!
Risk of squeezing
If the bed end is not correctly locked it can fall
down and cause injury to user.
– Make sure the locking pins are engaged.
Mounting
1. Align the slots in the bed end with the tabs on the
Sanne fitting.
2. Place the bed end onto the tabs.
3. Push down firmly and ensure that the bed end is fully
seated in the tabs.
4. Rotate the locking pin on both sides to allow it to
engage with the bed end.
Dismounting
1. Pull out the locking pin and rotate to temporarily
disengage from the bed end on both sides.
2. Hold the bed end firmly on each side and pull up
vertically on both sides at the same time.
10 1561872-F