6
Installing the Bath Lift into the Bathtub
(FIGURE 9)
WARNING
ALWAYS lower the bath lift frame to the
lowest position BEFORE performing this
procedure. Otherwise, the bath lift frame
may tip during installation and injury or
damage may occur.
The frame MUST be placed into an
EMPTY bathtub.
1. Clean tub and wipe suction cups with a damp cloth.
2. Press the DOWN button on the pendant to lower
the bath lift to the lowest position.
3. Grasp the handgrip on the battery pack and pull
upwards to remove it from the motor shroud as
shown in FIGURE 9.
4. Place the frame into the bathtub.
5. Perform the following steps to position the frame
in the bathtub:
A. Position the rubber pads of the frame just in front of
the curve at the bottom of the back of the bathtub.
B. Install the seat. Refer to INSTALLING THE
SEAT in this instruction sheet.
C. Position the frame to align the line on the entry/
exit side flap with the inside edge of the bathtub
as shown in DETAIL "G" of FIGURE 9.
WARNING
The frame must be positioned so that
the side flap of the seat on the entry/
exit side of the bathtub is fully sup-
ported by the side of the bathtub. The
inside edge of the bathtub MUST be
aligned with the line on this side flap.
D. Ensure the rubber pads and suction cups are
positioned flat on the bottom of the bathtub.
NOTE: Pull up on suction cup loops to release suc-
tion cups from bathtub bottom.
6. Press firmly down onto the two (2) front suction cups
to attach the frame securely to the bottom of the bath.
FIGURE 8 - INSTALLING THE MOTOR SHROUD
Mounting
Bracket
Spade Connector Wire Wrap
Pendant
Cable
Mounting Screw
STEPS 2-3
Pendant
Secure Here
DO NOT Secure Here
Current
Limit
Device
STEP 2
BLACK Spade
Connector Wire
(STEP 1)
RED Spade
Connector
Wire
(STEP 1)
Nut
Mounting
Bracket
Mounting
Screws
Pendant
Secure Pendant
Cable and Spade
Connector Wire
Wrap Together
(STEP 2)
To Current Limit
Device
STEPS 1 - 3
Mounting
Holes
Upper
Spade
STEPS 4-6
Motor Shroud
Self-locking
Screws
Washer
Machine
Screw
Washer
Motor
Lower Spade
