Flip over the side plate so the
standoffs are facing down.
Position an A Clip (Part 3) in the
TOP FRONT corner of the side
plate
There is an ‘A’ visible on the part
Place a Square Nut (Part 7) into
the square recess of the A Clip.
Insert an M4x8 bolt (Part 6)
from the outside of the side
plate, through the A Clip and
screw into the Square Nut
*Square Nut colour may differ
based on availability
Loosely tighten the bolt into the
Square Nut.
You will fully tighten these
bolts once your drives are in
place
You should end up with
something like this example
TERRAPI EXTREME DUO
Assembly Instructions Page 4 of 11
© INUX3D 2021
V1.1
