Open-X™ 8M Development Kit based on the NXP i.MX8™ Processor User Guide Version 1.0
15
Copyright Intrinsyc Technologies Corporation
3.8
Open-X 8M Carrier Board
The Open-X 8M Carrier board is a Mini-ITX form factor board with various connectors used for
connecting different peripherals. The following are the mechanical properties of the carrier board:
Dimensions
289 cm
2
(170mm x 170mm)
Form Factor
Mini-ITX
Major Interfaces
SOM: 3x100 pin board to board connector
Display: 100 pin carrier board connector
Boot dip switch Configuration Options
Two dip switches on the Open-X 8M carrier board provides the user options to configure the boot
mode and boot device. The table below show the supported boot modes on the Open-X 8M
Development Kit:
S701
BOOT_MODE 1
BOOT_MODE 0
BOOT SOURCE
0
0
Fuses
0
1
Serial Downloader
1
0
Internal (see BOOT Device)
1
1
Reserved (do not use)
The table below shows the supported boot devices on the Open-X 8M Development Kit:
BOOT Device
S700 [0:3]
Boot from eMMC
0010
Boot from SD2
1100
Figure 3-5 Boot Switches S700 and S701
