Open-Q™ 820 (APQ8096) / 820Pro (APQ8096SG) µSOM Development Kit User Guide Version 1.4
45
Copyright Intrinsyc Technologies Corporation
CSI PHY
Use case
Comment
CSI0 + CSI1
Up to 4 lane 3D
4 lane 3D use case / Dual 4 lane configuration
CSI 2
Up to 1 lane 3D
1 lane 3D use case / Dual 1 lane configuration
CSI0 + CSI1 + CSI2
Up to 4 lane
Three 4-lane CSI (4+4+4 or 4+4+2+1)
CPHY
Three 3-trio CPHY1.0
3.8.21 Power Header via 20 Pin Connector J60
Figure 25 J60 Power Connector
•
For providing camera connectors with additional current than what is originally
supported by on board regulators. This is to mitigate the effect of high resistance and
IR drop on flat cables which can violate camera sensor requirements for high
performance cameras
•
It is recommended to use this when high performance (high mega pixels) cameras are
being used. Usually high-performance cameras require more power
•
Can also be used as a general power header if user would like to use voltage rails
brought out by connector
Description
Signal
Pin NO
Description
Signal
Pin NO
1.05V
power rail
for camera
0
MB_ELDO_CAM0_DVDD J60[1]
2.85V power
rail for
camera 0
(AVDD)
VREG_L17A_2P8
J60[2]
2.8V power
rail for
camera 0, 2
(VDD)
VREG_L23A_2P8
J60[3]
GND
GND
J60[4]
