Operation Manual 5280 EPSP
42
8.1.1 Removing the knife
Figure 20.
8.1.1.1
Select the "Change knife" function on the programmer 1 screen (Fig.20)
("Programmer's manual").
8.1.1.2
Pressing the push buttons 2
(fig.20) at the same time, start the cutting cycle.
The knife 3 is held in the lower position.
8.1.1.3
. Turn off the power supply of the electrical system by turning the main switch knob
4 (fig.20) to the "0" position.
1
1
1
1
2
Figure.21
8.1.1.4
Remove the four screws 1 (fig.21) securing the cover 2 and remove the cover 2.
