235
PO
©2014 Intex Marketing Ltd. - Intex Development Co. Ltd. - Intex Trading Ltd. - Intex Recreation Corp.
All rights reserved/Tous droits réservés/Todos los derechos reservados/Alle Rechte vorbehalten.
Made in China/Fabriqué en Chine/Hecho en China/Hergestellt in China.
®™ Trademarks used in some countries of the world under license from/®™ Marques utilisées dans certains pays sous licence de/Marcas registradas
utilizadas en algunos países del mundo bajo licencia de/Warenzeichen verwendet in einigen Ländern der Welt in Lizenz von/
Intex Marketing Ltd. to/à/a/an Intex Trading Ltd., Intex
Development Co. Ltd., G.P.O Box 28829, Hong Kong & Intex Recreation Corp., P.O. Box 1440, Long Beach, CA 90801
• Distributed in the European Union by/Distribué dans l’Union
Européenne par/Distribuido en la unión Europea por/Vertrieb in der Europäischen Union durch/
Intex Trading B.V., Venneveld 9, 4705 RR Roosendaal – The Netherlands
www.intexcorp.com
SAVE THESE INSTRUCTIONS
(235PO)
WETSET SMALL EASY SET POOL FRENCH
6.5” X 9.75” 01/28/2014
POOL SET UP
IMPORTANT SITE SELECTION AND GROUND PREPARATION INFORMATION
•
The pool location must allow you to secure all doors, windows, and safety barriers to prevent unauthorized, unintentional or unsupervised pool entry.
•
Install a safety barrier that will eliminate access to the pool for young children and pets.
•
Failure to set up the pool on flat, level, compact ground and in accord with the following instructions could result in the pool’s collapse or the possibility
that a person lounging in the pool could be swept out, resulting in serious injury or property damage.
Select an outdoor location for the pool with the following in mind:
1.
The area where the pool is to be set up must be
absolutely flat and level. Do not
set up the pool on a slope or inclined surface.
2.
The ground surface must be compacted and firm enough to withstand the pressure and weight of a fully set up pool.
Do Not
set up
the pool on mud, sand, soft or loose soil condition, deck, platform, concrete, asphalt or any other hard surfaces.
3.
Pool fencing laws may affect this product. Consult your local council and set up this product accordingly.
4.
Certain types of grass such as St. Augustine and Bermuda, may grow through the liner. Grass growing through the liner it is not a manufacture defect.
Barriers for Residential Swimming Pool Guidelines:
An outdoor swimming pool, including an inground, aboveground, or onground pool, hot tub, or spa, should be provided with
a barrier which complies with the following:
1.
The top of the barrier should be at least 48 inches above grade measured on the side of the barrier which faces away from the swimming pool. The
maximum vertical clearance between grade and the bottom of the barrier should be 4 inches measured on the side of the barrier which faces away
from the swimming pool. Where the top of the pool structure is above grade, such as an aboveground pool, the barrier may be at ground level, such
as the pool structure, or mounted on top of the pool structure. Where the barrier is mounted on top of the pool structure, the maximum vertical
clearance between the top of the pool structure and the bottom of the barrier should be 4 inches.
2.
Openings in the barrier should not allow passage of a 4-inch diameter sphere.
3.
Solid barriers, which do not have openings, such as a masonry or stone wall, should not contain indentations or protrusions except for normal
construction tolerances and tooled masonry joints.
4.
Where the barrier is composed of horizontal and vertical members and the distance between the tops of the horizontal members is less than
45 inches, the horizontal members should be located on the swimming pool side of the fence. Spacing between vertical members should not
exceed 1-3/4 inches in width. Where there are decorative cutouts, spacing within the cutouts should not exceed 1-3/4 inches in width.
5.
Where the barrier is composed of horizontal and vertical members and the distance between the tops of the horizontal members is 45 inches or
more, spacing between vertical members should not exceed 4 inches. Where there are decorative cutouts, spacing within the cutouts should not
exceed 1-3/4 inches in width.
6.
Maximum mesh size for chain link fences should not exceed 1-1/4 inch square unless the fence is provided with slats fastened at the top or the
bottom which reduce the openings to no more than 1-3/4 inches.
7.
Where the barrier is composed of diagonal members, such as a lattice fence, the maximum opening formed by the diagonal members should be
no more than 1-3/4 inches.
8.
Access gates to the pool should comply with Section I, Paragraphs 1 through 7, and should be equipped to accommodate a locking device.
Pedestrian access gates should open outward, away from the pool, and should be self-closing and have self latching device. Gates other than
pedestrian access gates should have a self-latching device. Where the release mechanism of the self-latching device is located less than
54 inches from the bottom of the gate, (a) the release mechanism should be located on the pool side of the gate at least 3 inches below the top
of the gate and (b) the gate and barrier should have no opening greater than 1/2 inch within 18 inches of the release mechanism.
9.
Where a wall of a dwelling serves as part of the barrier, one of the following should apply:
(a)
All doors with direct access to the pool through that wall should be equipped with an alarm which produces an audible warning when the door
and its screen, if present, are opened. The alarm should sound continuously for a minimum of 30 seconds within 7 seconds after the door is
opened. Alarms should meet the requirements of UL 2017 General- Purpose Signaling Devices and Systems, Section 77. The alarm should
have a minimum sound pressure rating of 85 dBA at 10 feet and the sound of the alarm should be distinctive from other household sounds,
such as smoke alarms, telephones, and door bells. The alarm should automatically reset under all conditions. The alarm should be equipped
with manual means, such as touchpads or switches, to temporarily deactivate the alarm for a single opening of the door from either direction.
Such deactivation should last for no more than 15 seconds. The deactivation touchpads or switches should be located at least 54 inches
above the threshold of the door.
(b)
The pool should be equipped with a power safety cover which complies with ASTM F1346-91 listed below.
(c)
Other means of protection, such as self-closing doors with self-latching devices, are acceptable so long as the degree of protection afforded
is not less than the protection afforded by (a) or (b) described above.
10.
Where an aboveground pool structure is used as a barrier or where the barrier is mounted on top of the pool structure, and the means of access is a
ladder or steps, then (a) the ladder to the pool or steps should be capable of being secured, locked or removed to prevent access, or (b) the ladder
or steps should be surrounded by a barrier. When the ladder or steps are secured, locked, or removed, any opening created should not allow the
passage of a 4-inch diameter sphere. Barriers should be located so as to prohibit permanent structures, equipment or similar objects from being
used to climb the barriers.
SET UP:
Depending on the size of the product, 2 or more adults are recommended for setup. Set up time may vary from 10 to 20 minutes
excluding water fill time.
1.
Find a flat, level lawn surface that is free and clear of stones, branches or other sharp objects that may puncture the pool liner
or cause injury.
2.
Move the product (in its package) to the selected site before inflating – do not inflate the product and drag it since it may result in
leaks or damage.
3.
Slowly unfold the product and inspect the product for rips, tears or punctures. Do not use if the product is damaged.
4.
Lay the pool out as evenly as possible and close all drain plugs and/or exhaust valve caps if any.
5.
Flip the top ring out and check that it is fully outside of the wall lining and facing up. Keep the top ring centered in the middle of
the pool.
WARNING
